Plumbing has so many possibilities as to what you can use, do, and how you can apply it to your own plumbing jobs. It is rare to find somebody that has plumbing needs just like you, so why not take advantage of that and perfect your own? This article can help you.
The next time you have a clogged drain, avoid the simple solution of dumping drain-clearing chemicals into the pipes. While this method involves the least amount of effort, the chemicals in these liquid cleaners are destructive to your piping. Instead, consider using a little bit of elbow grease with a plunger, snake, or other device designed to clear your clog without chemicals.
To winterize a house that will sit unused during the winter months, you must completely drain all of the pipes. After turning off the main water supply, let all of the water drain from the faucets, toilets, and water heater (turn off the gas). Add a quart of antifreeze to sinks and the tub to prevent water from freezing in the drain trap.
Periodically check your pipes for leaks and cracks. These can be forgotten, since pipes are usually hidden away, but checking for leaks and cracks can help you identify a small problem before a big problem occurs. You may have to enlist the help of a family member to turn on and off the water stream as you are checking.
Check carefully around the base of your toilet for any damage caused by leaks. Sit in a reversed position, putting one foot on each side of the toilet and shift your weight from side to side to check if the floor feels slightly unstable. Discovering this issue sooner can mean big savings for your checking account, as compared to finding out about it later.
If you notice water draining into your dishwasher, check how the kitchen sink hoses are installed. The hose going from the dishwasher to the sink must go downhill, and then uphill, to prevent water mixing from the two devices.
Remember that your toilet is not intended to be used to dispose of trash. Don’t flush anything that is unlikely to dissolve and wind up clogging pipes, such as diapers, tissues, paper towels and cotton balls. Also, you want to use the least amount of toilet paper to clean yourself.
Sometimes you have to make the choice between replacing or repairing. If you have an old appliance, that uses a lot of water or electricity, it may be best to replace. Sure, it will cost more initially, but it will save you money in the long run. The other thing is, you can’t be sure how well a repair will work out, whereas with a new appliance you’ll at least get a guarantee.
One way to avoid a common plumbing problem is to make sure never to flush anything but human waste and toilet paper down a toilet. Other things made of paper like tissues, paper towels, and the like do not dissolve the same way toilet paper does and can get stuck.
In any DIY plumbing project, make sure that you always test the drains and the supply lines before you close up the walls. It is a lot easier to find and solve problems if you look for them while you are still in the process of actively doing the job.
Every now and then, you should pour a large bucket of water down your basement floor drain. This will help to keep the trap seal full and prevent certain gases from coming up into your home. Also, be sure that you have your floor drain checked by a professional every few years.
When getting an estimate from a contractor on a job, make sure to ask how long the written estimate is good for. For big jobs you usually want to get estimates from a few different plumbers. Knowing how long your estimate is valid will help you know what your time limit is for making a decision on who to hire.
Everyone in your family should know exactly where your home’s main water shut off valve is and how to use it. The water meter should be located in its vicinity. Toilets, sinks and other fixtures could have their own valves that cut off. Inform all the members of your family where they can find the valve, and also show them how to shut them off if they are leaking.
Plumbing requires more skill then just an understanding of water. A common task for a plumber is repairing water lines.
If you have a leak and your water bill is going up, there is a method you can try before you call a professional. You can use the red-dye system to detect whether the leak is above ground, underground, or whether it has anything to do with the toilets.
If you have an ice maker or other plumbing going to your refrigerator, every six months or so pull the refrigerator away from the wall and inspect this plumbing. There should be no condensation or corrosion on these plumbing lines, if there is, contact a plumber and have them look at it.
If, when you’re installing your new water heater, you notice that a pipe is extending from your draining pipe, make sure it’s reconnected. This is probably the re-circulation pipe. It is handy for enabling the most efficient water usage.
A great way to save a few dollars is to add insulation to your hot water heater. Much of the energy required to heat the water in your home is the expense from keeping the water in the tank hot for when it is needed. Adding an extra layer of insulation can help reduce this cost.
Isn’t doing your own plumbing a lot of fun? As you have seen in this article, there are a lot of ways this can be done and no two techniques or equipemnt will yield the same results. There are also lots of customizable options that can work with your home and budget.